Block making machines, such as concrete block machinery, are gaining attention in developed as well as developing countries for their fast, reliable, and also robust outcomes. While these machines are very effective, maintaining them is also very important. 

These machines have to work in the worst weather conditions, not forgetting the gravel, sand, and micro dust to which they are exposed.

Due to the harsh conditions under which these concrete block makers have to work, it is essential to provide regular maintenance so it can perform well and the machine can work with the same efficiency. 

Best ways to maintain block making machines

Never neglect abnormalities

1. Abnormalities Detection: In the event of any abnormalities being detected, the machine should be stopped from working as soon as possible to avoid further abnormalities. The cause of the abnormality should be investigated. A minor fault can cause the entire system to fail, so detecting this fault is critical.
2. Short Check: To avoid major loss, a short performance check is necessary, before even starting concrete block machinery, to make sure everything is working fine. Before putting the machine to work, lubrication, performance anomalies, malfunctioning parts, tightening, and a few other examinations can be done. This will prevent the entire system from failing and stopping work in the middle.

Trained professionals to handle the concrete block making machines

It is much worse to have an unskilled person perform maintenance and servicing than to not do any maintenance at all. A minor fault which gets neglected or not attended to properly can result in a massive fault. 

As a result, it should be ensured that all repairs and service are performed by qualified professionals exclusively. Maintaining a block making machine"s mechanical parts in good condition makes it more reliable, increases its efficiency, and increases its lifespan.

What does a trained professional do? 

1. Routine check

Make sure that the block making machines fasteners are tight before using it. Parts that require lubrication should be lubricated according to requirements.

2. Regular inspection

Check whether the mechanical control system and limit switches are normal. Make sure the control components are functioning as required.

3. Read and understand the equipment manual

Before you start the equipment, double-check that all of the parts, programme settings, and so on are in working order. Use the machine in accordance with the operating procedures, monitor its operation, and shut it down promptly if any irregularities are discovered. After using the machine, make sure to clean it according to the instructions.

4. Low/High Temperature Maintenance

When it comes to concrete hollow block making machines, production is not the same in winter and summer; the weather makes a huge difference. Often, in production, water is used in materials, and low temperatures cause materials to freeze. 

To avoid this, antifreeze usage should be encouraged, and raw products should also be insulated. Low temperatures can also affect lubricants, so antifreeze is also recommended in lubricants. 

It is advised to drain all the hydraulic fluids to avoid freezing the machine when you put it to sleep.